Clock Setting - Espressione 26260 Manual Del Usuario

EN
PROGRAMMING PHASES
Auto start programming (Drip coffee automatic start time setting)
• Press the button "programming"(F) only once.
The icon (B) starts fl ashing together with the time.
• Press the arrow buttons "
time the value 12 is reached, "AM" or "PM" are shown alternatively).
• Press the button "programming"(F) again.
The digits of minutes start fl ashing.
• Press the arrow buttons "
The Auto start function is on and programmed to make coffee at the set time.
• Press the button "programming"(F) for the third time to enter the heating plate heat maintaining pro-
gramming.
Heating plate heat maintaining programming
The default duration of this function and the following automatic switching off is set in 2 hours from the
last dispensing cycle.
• The 1 digit value of the duration (in hours) of the function fl ashes.
• Set the required hour number (from 1 to 5) by pressing the arrow buttons "
times.
The function "Heating plate heat maintaining time programming" is set.
• Press the button "programming"(F) for the fourth time to enter the clock setting.

Clock setting

The icon (C) starts fl ashing together with the time.
• Press the arrow buttons "
single time the value 12 is reached, "AM" or "PM" are shown alternatively).
• By pressing the button "programming" (F) for the fi fth time, the above described settings are stored.
Please Note: The fl ashing of ":" between hours and minutes shows that the clock is working
properly and the exit from the programming mode.
" " to set the time. (As the clock has a 12 hour display, every single
" " to set the minutes.
" " " to set the time. (As the clock has a 12 hour display, every
8
" or " " several