Espressione 26260 Manual Del Usuario página 9

HOW TO MAKE CAPUCCINO
• Pour approximately 200ml of skimmed milk into a small but high container into which the steam wand
(13) can be inserted.
Please Note: use quality, fresh and cold milk; the container must be cold, too, therefore do not
rinse with warm water before the use.
• Position the steam dispensing valve (12) in position '
• Place a container with milk under the steam wand (13).
• Press the button 1 cup/2 cups (I), the button "ESPRESSO" starts fl ashing.
• Once the button "ESPRESSO" turns off, rotate the steam dispensing valve (12) anti-clockwise slowly
to "MAX" position direction.
• During the froth preparing phases, be careful the capuccino maker (14) does not touch the container
bottom to avoid obstruction of steam dispensing.
• Once having got the froth (this could take 10-30 seconds), reposition the steam dispensing valve (12)
into position '●' and remove the container.
• After the above steps, dispense steam for few seconds to clean the hole of the steam wand (13) and
remove possible milk remains. Clean the outside part of the steam wand and the capuccino maker
(14) by means of a damp cloth.
Warning!
Do not touch the steam nozzle parts during the dispensing phases as they are very hot. Burn
hazard.
Use only containers with material suitable for high temperatures (ceramic or steel).
SETTABLE FUNCTIONS
The machine is equipped with three settable functions.
• Drip coffee auto start time setting.
• Heat maintaining time setting.
• Digital clock setting.
When the appliance is connected to an electric socket, the "LCD Display" (24) shows the default time
setting by proposing the value 12:00AM.
• At every press of the button "PROG" (F) the following function is selected:
Drip coffee auto start (in hours)
Drip coffee auto start (in minutes)
Heating plate heat maintaining (in hours)
Clock (in hours)
Clock (in minutes)
Exit (settable functions)
Please Note: In programming mode, in case of a delay over 10 seconds between the press of a
button and the next one, the program quits automatically the programming mode by maintaining
the last shown values, then the display turns off.
If the appliance is disconnected or blackout occurs, settings are resetted.
'.(Fig.8)
7
EN