Connections; How To Connect The Ac Power Cord - Sony Trinitron PVM-14L2MD Manual De Instrucciones

Expandable input capability
You can easily expand the input capability by installing
an optional board (not supplied) in the option slot on the
rear panel. Only one board for expanding the input
capability can be installed at a time.
External sync input
Selecting the RGB/EXT item of RGB SYSTEM on the
Menu screen enables the monitor to operate on a sync
signal supplied from an external sync generator.
For more details, see page see page 28.
Automatic termination (only for connectors
with a mark)
The input connector is terminated at 75 ohms internally
when nothing has been connected to the output
connector. If a cable is connected to the output
connector, the internal terminal is automatically released
and the signals input to the input connector are output to
the output connector (loop-through).
Functions
Auto chroma phase function
The chroma and phase are automatically adjusted.
Overscan mode
The size of the image on the screen is increased by
approximately 20% to make the center of the picture
easier to see.
Underscan mode
In the underscan mode, the lines usually scanned outside
the normal display area are visible so that you can
monitor the entire screen area.
Note
When the monitor is in the underscan mode, dark RGB
scanning lines appear on the top edge of the screen.
These are caused by an internal test signal.
Auto/manual degaussing
The monitor is automatically degaussed when the power
is turned on. You can manually degauss the monitor by
pressing the DEGAUSS button.
Using the menu, you can preset a time to degauss
automatically after the power has been turned on for a
while.
On-screen menus
You can set color temperature, perform a chroma set up,
and make other settings using the on-screen menus.
22
Features / Connections
Options
EIA 19-inch rack mount bracket available
The monitor can be mounted on an EIA-standard
19-inch rack, using the following mounting brackets or
slide rails.
For the PVM-14L2MD: MB-502B (In Europe, use the
MB-502C)
For the PVM-20L2MD: SLR-103A (In Europe, use the
SLR-103C)
For details on mounting the monitor on the rack, refer to
the user's manual of the mounting bracket or slide rail.

Connections

How to Connect the AC Power Cord

To connect the AC power cord
Plug the AC power cord into the AC IN socket. Then,
attach the AC plug holder (supplied) to the AC power
cord and slide it over the cord until it locks.
AC IN socket
AC plug holder
To remove the AC power cord
Pull out the AC plug holder while pressing the lock
levers.
AC power cord
lock levers