Troubleshooting - Electrolux EHH6332FOK Manual Del Usuario

TROUBLESHOOTING

You cannot activate the
appliance or operate it.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
The appliance deactivates. You put something on the
The residual heat indicator
does not come on.
The Automatic Heat Up
function does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
comes on.
Problem Possible cause and
You touched 2 or more
sensor fields at the same
time.
The Stop+Go function
operates.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor fields.
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting is
set.
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function oper-
ates.
No cookware is on the
cooking zone.
ENGLISH
Remedy
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
Touch only one sensor
field.
Refer to the chapter "Oper-
ating instructions".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the cooking zone operat-
ed sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as the
Automatic Heat Up func-
tion.
Refer to "Power manage-
ment".
Put large cookware on the
rear cooking zones if nec-
essary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Oper-
ating instructions".
Put cookware on the cook-
ing zone.
13