Display Function Modes; Parameter Display Mode; Command And Safety Device Status Display Mode - Roger Technology B70/1DC Manual De Instrucciones

10

Display function modes

10.1

Parameter display mode

PARAMETER
PARAMETER
See chapter 13 for detailed descriptions of parameters.
10.2

Command and safety device status display mode

COMMAND STATUS
AP PED
PP
CH
ORO
POWER
COMMAND STATUS:
The command status indicators on the display are normally OFF.
They ILLUMINATE when a command is received (e.g.: when a step mode command is received, the segment PP
illuminates).
SEGMENT COMMAND
AP open
PP step by step mode
CH close
PED partial opening
ORO clock
SAFETY DEVICE STATUS:
The safety device status indicators on the display are normally ON.
If an indicator is OFF, the relative device is in alarm state or is not connected.
The an indicator is FLASHING
SEGMENT SAFETY
FT1 photocell
FT2 photocell
COS1 sensing edge
COS2 sensing edge
FA gate open limit switch
FC gate closed limit switch
SB release handle open
VALUE
SAFETY DEVICE STATUS
FT1
COS1
COS2
SB STOP
FT2
69