PROTEOR 1P650 Instrucciones De Montaje Y Ajuste página 12

VII. CHANGING POSITION
To switch from SLIDING mode to BIKING mode, you have to change the upper axis of the cylinder from position 1 to
position 2 as follows :

Undo the two screws on either side of the axis using the two T30 Torx wrenches provided.

Remove the axis from its place using the provided axis change tool.

Insert the axis in the required place.

Re-position the two screws with their washers and with a drop of XC048 glue, then tighten them up to a 6 Nm torque.
SLIDING POSITION
Extension (12° pre-flexion)
1
- To tighten and to loose the screws, please use a torque wrench fitted with a T30 Torx tip.
- In case of deformation of the impression on the screw head, replace this screw by one of the two screws provided.
- The maximal flexion stops in BIKING position aim only at protecting the cylinder and can in no case be subject to
regular and repeated stresses.
VIII. SELECTION OF THE POSITION AND AJUSTMENTS ACCORDING TO THE ACTIVITY
The cylinder has three controls for adjustment:

Blue control (FIRM / MEDIUM /OPEN) for respectively low, medium and fast compression
speed.

Black control (ADJUSTING TRAIL MODE) for fine adjustment of compression speed. It can be
used in OPEN Mode only and has 3 positions : 1, 2 and 3 from soft to firm.

Red control (REBOUND) for the speed of extension assist.
Flexion (50° range)
BIKING POSITION
Extension (no pre-flexion)
2
6, rue de la Redoute - 21850 - SAINT APOLLINAIRE -FRANCE
Tél: 33 (0)3 80 78 42 10 - Fax: 33 (0)3 80 78 42 15
ht.orthopedie@proteor.com - www.proteor.com
1P65099-1116 page 12/32
Flexion (130° range)
PROTEOR