Fitting Seat Plate - Invacare Aquatec Ocean E-VIP Manual Del Usuario

Aquatec® Ocean E-VIP
Adjusting Chest Belt Position
Risk of Damage
– Adjust the position of the chest belt to suit the
user.
– Adjust the position of the two mounting
brackets equally on both sides.
– The position of the right and left mounting
brackets is adjusted in the same way.
1. Open the belt buckle on the backrest cover which is
passed on the inside of the backrest frame at the height
where the chest belt is secured.
2. Open the belt buckle on the backrest cover at the
height where the chest belt is to be fitted.
3. Pass this belt on the inside of the backrest frame and
close it again.
4. Remove hand knob A.
5. Remove chest belt E.
6. Remove both parts of the mounting bracket B and D
and move them to required position.
7. Place inner part D of the mounting bracket around the
backrest frame so that the hole faces backwards.
8. Place the outer part B of the mounting bracket in the
hole of the inner part.
9. Attach the two parts of the mounting bracket in the
required position on backrest frame with screw C.
10. Attach chest belt E with hand knob A to the mounting
bracket.
11. Pass the open belt of the backrest cover on the outside
of the backrest frame and close it again.
12. Tighten all belts.
14
Adjusting Chest Belt Length
Adjust the length of the chest belt to suit the user.
The length of the chest belt is adjusted via the belt buckle
in the chest belt. If the belt buckle adjustment range is
insufficient, adjust the length at the mounting brackets as
follows:
1. Remove hand knob A.
2. Use holes in chest belt E to select the length.
3. Use hand knob to fix chest belt to mounting bracket.

4.6 Fitting Seat Plate

CAUTION!
Risk of Pinching Fingers
– Do not put fingers between the seat surface
and seat frame when pressing down the seat
plate.
Installation
B
A
Fig. 4-5
1556395-D