Fitting Chest Belt - Invacare Aquatec Ocean E-VIP Manual Del Usuario

To adapt it to the user, the height adjustment tube
can be fitted with the curve facing the front or the
back.
The headrest pad J can be removed and replaced
by other pad shapes (optional). To remove it, loosen
the retaining bolts I.
Adjusting the Length of the Headrest
The headrest tubes C and B can be shortened if
required (refer to the service manual). Shortening
the headrest tube must be performed by a qualified
technician.

4.5 Fitting Chest Belt

Risk of Damage
– Install both mounting brackets at the same
height
– Installation of the left and right mounting
brackets is laterally inverted.
1556395-D
1. Open the belt buckle on the backrest cover at the
height where the chest belt is to be fitted.
2. Pass this belt on the inside of the backrest frame and
close it again.
3. Place inner part D of the mounting bracket around the
backrest frame so that the hole faces backwards.
4. Place the outer part B of the mounting bracket in the
hole of the inner part.
5. Attach the two parts of the mounting bracket in the
required position on backrest frame with screw C.
6. Attach chest belt E with hand knob A to the mounting
bracket.
C
A
Fig. 4-4
Setup
13