Safety Decals - Allmand PORT-A-LITE Manual Del Operador

WARNING
Modification Hazard
• Never modify the equipment without written consent of
the manufacturer. Any modification can effect the safe
operation of the equipment.
WARNING
Rollover Hazard
• Do not raise, lower or use the work light unless
positioned on firm ground.
• Never move or reposition the work light while the mast
is fully extended.
WARNING
Burn Hazard
• Light fixtures become very hot during operation and
shortly after shutdown.
• Handle hot components, such as light fixtures, with heat
resistant gloves.
NOTICE
• Any part which is found defective as a result of
inspection or any part whose measured value does not
satisfy the standard or limit MUST be replaced.
• Always tighten components to the specified torque.
Loose parts can cause equipment damage or cause it
to operate improperly.
• The use of authorized Allmand
encouraged. The warranty does not cover damage or
performance problems caused by the use of parts that
are not authorized replacement parts.
• Clean all accumulated dirt and debris away from the
body of the equipment and its components before
you inspect the equipment or perform preventative
maintenance procedures or repairs. Operating
equipment with accumulated dirt and debris will cause
premature wear of equipment components.
• Retrieve any tools or parts that may have dropped
inside of the equipment to avoid improper equipment
operation.

Safety Decals

Before operating your unit, read and understand the following
safety decals. The cautions, warnings and instructions are for
your safety. To avoid personal injury or damage to the unit,
understand and obey all the decals.
Keep the decals from becoming dirty or torn, and replace
them if they are lost or damaged. Also, if a part needs to be
replaced that has a decal attached to it, make sure to order
the part and decal at the same time.
Compare Figure 1 with the tables following.
®
replacement parts is
1
Domestic / CSA Models
3