Preparing For Set-Up; Set-Up Instructions - Allmand PORT-A-LITE Manual Del Operador

Ref
J Cable Tie
K Mast Socket Knob
L Base Assembly
M Power Switch
Set-Up

Preparing For Set-Up

® ®
Allmand Port-A-Lite PAL LED portable work lights are
shipped in separate cartons, and require assembly before
use. Upon receiving the unit, remove each piece from
the shipping cartons and inspect the parts for damage.
Contact your dealer or Allmand if parts were damaged during
shipping.

Set-Up Instructions

1. Loosen the mast socket knob (A, Figure 3).
2. Insert the outer mast (B, Figure 3) in the socket, and
tighten the knob.
3. Make sure the inner mast (C, Figure 3) is completely
lowered, and that the latch spring pin (D) is engaged in
the hole in the inner mast.
4. Place the center hole of the fixture yoke (E, Figure 3)
onto the stud on the inner mast, and secure with the
plastic washer (F), flat washer (G) and jam nut (H). Do
not overtighten.
5. Remove the cable tie (I, Figure 3) from the base cable (J).
6. Connect the base cable to the fixture cable (K, Figure 3).
6
Description
3
Operation
Preparing The Unit For Use
WARNING
Unsafe Operation Hazard.
Operating the unit with worn, damaged or missing parts
can result in death or serious injury. Always replace worn,
damaged or missing parts promptly. Do not operate this
unit until all worn, damaged or missing parts have been
replaced, and proper operation of unit has been verified.