About Disassembly - AquaTools AT5800 El Manual Del Propietario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

1. Remove swivel assembly (Figure 17) from the top of the

cleaner by turning it 1/4-turn counterclockwise and

pulling straight up on it.

2. Turn cleaner upside down. Remove 4 screws and

remove lower body assembly from shroud.

3 . Turn lower body assembly right side up. Unsnap the 2

clips on the oscillator chamber cap (Figure 18A); lift it

off.

4. Pull the long gear shaft straight up (Figure 18A) by the

blocks on the ends of the shaft. Hold the seals in the

oscillator and the blocks on the shaft. The cam may

interfere with the shaft mounting post; if so, turn it

slightly on the shaft until it clears the post. The shaft

assembly can now be disassembled (Figure 18B).

5. Slide the long gear shaft out of the oscillator (with

gears, complete); make sure that you don't lose the

seals out of the oscillator which may fall out at this

point (Figure 18B).

5A. Oscillator seals are replaceable.

5B. Ratchet gear set and long shaft are replaceable as a

unit.

6. Remove the set screw, short gear shaft, and gears

(Figure 19); do not lose the gears off of the shaft.

7. With a small screwdriver (such as a jeweler's screw-

driver), a pencil, or a pen point, depress and remove

the coil spring from the lift brush mounting post (Figure

20). Replace the brush and the spring if necessary.

8. The metal ratchet tab slides out of its slot sideways;

replace it by removing the center brushes and sliding in

a new ratchet tab until it is flush with the edge of plas-

tic holder (Figures 21 and 22). Replace the center

brushes.

9. The brush ring pops out of the cleaner body for easy

replacement.

10. If you need to replace the bumper, turn the shroud and

bumper assembly upside down and remove the two

screws holding the bumper to the shroud.

If you have any questions, please call 1-800-752-0183