About Installation - AquaTools AT5800 El Manual Del Propietario

Please use the convenient, water resistant, "Installation Instructions" card.
Step 1: Install vacuum port door fitting
If there is no spring-loaded door on the vacuum port,
install the included cover.
If you pool only has a skimmer, and no dedicated vacu-
um port, proceed to Step 2.
Figure 1
1. Screw the fitting into the port opening.
2. Orient the fitting so the arrow on the door points up.
3. Secure the cover by tightening the allen-screw below the
door.
Step 2: Straighten hose (Figure 2)
Remove and uncoil the hose from the carton. Lay it out
in the sunlight, flat and straight.
Figure 2
Step 3: Check parts (Figure 3)
Cleaner, black plastic swivel assembly, white rubber
reducer cone, one 20', one 8', and one 4' hose, white
plastic vacuum regulator, regulator cap, vac port fitting
and flow gauge.
Cleaner
Handle
Hose
8' 4'
20'
1902 0795
Figure 3

ABOUT INSTALLATION

1882 0795
Swivel
Reducer
Ass'y
Cone
Flow
Gauge
Vacuum Regulator
Regulator
Port
Cap
Step 4: Clean filter system (Figure 4)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
Figure 4
Step 5: Adjust valves for vacuuming (Figure 5)
Decide on the vacuum connection you are going to use
(either a skimmer or a dedicated wall fitting) and adjust
the pump valves (if your system has valves) to direct all
vacuum there.
Close the main drain (also see "About Fine Tuning the
Vacuum", Page 5).
Vac
Port
Figure 5
Step 6: Assemble cleaner (Figure 6)
Insert swivel assembly into cleaner; twist 1/4 turn.
Swivel
Assembly
Figure 6
3
1880 0795
Skimmer
1876 0795