About Assembly - AquaTools AT5800 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Seals
Figure 23
Make sure Oscillator
is partially inserted in
chamber while reinstalling
Shaft Assembly
Oscillator
Chamber
Figure 24
Figure 25
Start here with
large button when
installing vacuum skirt.
'Outside' will show
(facing out) when
skirt is correctly installed.
Figure 26
If you have any questions, please call 1-800-752-0183

ABOUT ASSEMBLY

1894 0795
Swing Cam
Arm up for
Clearance
O U
Rubber
T S
I D E
vacuum skirt
1893 0795
1. Put both white seals in the oscillator; hold them in place.
2. Install the oscillator on the long gear shaft. Install the
ratchet gear on the shaft so that the teeth engage the
ratchet on the oscillator. Install the spring, ratchet drum,
pinion gear (large gear first), and cam (gear end first) on
the shaft (See Figure 23). Hold the gears on the shaft
while installing them, and compress the clutch spring to
allow assembly to slip into place between the posts (See
Figure 23).
3. Install the long gear shaft and end blocks in the cleaning
head with the large arm of the cam down (see Figure
24).
4. Reinstall the short gear shaft, set screw, and two gears
(See Figure 25); the small pinion gears and the shaft set
screw go on the side toward the end of the cleaner –
away from the oscillator box. Make sure that the gears
engage the gears on the long gear shaft.
5. Install the oscillator chamber cap and clip it in place.
6. Install the rubber vacuum skirt on the cleaner with the
word 'OUTSIDE' showing. Start at the large pin on the
back of the cleaner head (See Figure 26) and work
around the cleaner. Make sure the skirt is flush against
the stop strips on the cleaner head (see Figure 27).
7. Turn the cleaner over. If you removed the bumper and
brush ring, replace them now.
8. Install the lower body assembly in the shroud. Fasten the
cleaning head in place with 4 screws (2 long, 2 short –
see Figure 28).
NOTE: Make sure that you do not dislodge the rubber
vac skirt while inserting the lower body assembly past
the brush ring.
This
Figure 27
#10-16x1-3/4" Screws
Center
Brush
Location
#10-16x1" Screws
Bottom View of Cleaner
Figure 28
11
Not
This
Lift Brush
Location
Center
Brush
Location
1891 0795

Publicidad

Tabla de contenido
loading

Tabla de contenido