Patek Philippe SELF-WINDING CYLINDER Manual De Instrucciones página 6

LAUNCH OF
THE WINDING CYCLE
Before following the procedure below, make sure that the
rotary winding case is turned off to prevent it from rotating.
To do this, press again the ON/OFF LED button. If the unit
was turned off, it will turn back on and indicate the battery
life level. Then turn off the rotary winding case again.
Note: After the On/Off LED Button is released. The LED bright-
ness will gradually fade to dark. Indicating to the user that the
rotary winder is turning off.
8
1. Open the case by carefully unclipping the snap of the
leather tongue , which allows an immediate opening of
the lid , so preserving the leather tongue.
2. Remove the watch support*
with the rotary winding case.
3. Position your watch in the centre of the watch support .
Adjusting the bracelet may be necessary. (Note: If there is
no watch on the watch support , the cycle cannot start).
*Your Patek Philippe rotary winding case comes with 2 different sizes of watch
supports . Make sure to choose the right support for your watch model.
9
by unclipping it in line