Dc Current Measurements - koban KMD-15 Instrucciones Operativas

KMD-15
DIGITAL MULTIMETER

DC CURRENT MEASUREMENTS

CAUTION: Do not make current measurements on the
10A scale for longer than 30 seconds. Exceeding 30
seconds may cause damage to the meter and/or the test
leads.
1. Insert the black test lead banana
plug into the negative (COM) jack.
2. For current measurements up to
200mA DC, set the function switch
to the highest DC mA position and
insert the red test lead banana plug
into the (mA) jack.
3. For current measurements up to
10A DC, set the function switch to
the 10A range and insert the red test lead banana plug
into the (10A) jack.
4. Remove power from the circuit under test, then open up
the circuit at the point where you wish to measure
current.
5. Touch the black test probe tip to the negative side of the
circuit.
Touch the red test probe tip to the positive side of the
circuit.
14 www.grupotemper.com