Clean The Float Ball; Clean The Ejector Nozzle - Nederman A Serie Manual De Instrucciones

EN A - Vacuum Cleaners
6.1.1
6.1.2
6.1.3
26
NOTE! Clean the filter after each use.
1. Turn off vacuum cleaner.
2. Empty dust from filter into a container or dust bag.
3. Clean cartridge filter by tapping it lightly on the floor.
NOTE! If using a washable filter, it can be washed with water and
detergent. Let it air dry.
NOTE! Replace cartridge filter after it has been washed twice.
NOTE! If cartridge filter is placed into a dust bag for disposal, tie off the
dust bag, see Figure 7.
4.
Shake filter bag.
Manual reverse air cleaning
Depending on the model, the vacuum cleaner uses one of two methods for
manual reverse air cleaning of filters, see Figures 8 and 9.
Figure 8
1. Turn on vacuum cleaner.
2. Handle position during vacuuming 8(A).
3. Move handle to position 8(B) for filter cleaning.
4. Repeat three times.
Figure 9
1.
Turn on vacuum cleaner.
2.
Disconnect hose 9(A).
3.
Open and close lid 9(B).
4.
Repeat three times.
Compressed air filter cleaning
1.
Turn on compressed air.
2.
Close ball valve on ejector top, and clean for 15 seconds. See figure 1(B).
3.
Turn off compressed air to stop cleaning.
4.
To repeat filter cleaning, turn on compressed air again for an additional
15 seconds. Repeat as necessary.
5.
Open the ball valve on ejector top to start vacuuming. See figure 1(C).
NOTE! If the vacuum cleaner comes with a control system for timer controlled
cleaning, see it's settings instructions for information regarding its use.
Replace the cartridge filter or filter candles
WARNING! Risk of personal injury.
•
Always use proper protective equipment where there is a risk for exposure
to dust, see Figure 7.
•
Wear an approved breathing mask, and do not spread dust when cleaning
or replacing filters, see Figure 7.