Kit Assembly - Metra 99-9107B Instrucciones De Instalación Para

ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio .
2. Secure the Single DIN Brackets to
the radio with the screws supplied
with the radio. (Figure A)
3. Slide the radio into the radio housing
until the side clips engage. (Figure B)
4. Snap the ISO Trim Plate into the
Radio Housing. (Figure B)
5. Slide the included pocket into the
radio housing until secure. (Figure C)
6. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
7. Install the assembled kit assembly
into the dash.
ATTENTION:
Once the dash kit is
snapped in, it cannot be removed
without dash panel removal.

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
®
99-9107B
Double DIN radio provision
1. Cut and remove center divider from
radio housing. (Figure A)
2. Snap the DDIN brackets to the inside
edge of the radio housing. (Figure B)
3. Slide the DDIN radio into the DDIN
bracket/radio housing assembly
and secure the radio to the kit
using the screws supplied with the
radio. (Figure C)
4. Snap the DDIN trimplate onto the
housing/radio assembly. (Figure C)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation
Install the assembled kit
6.
assembly into the dash.
ATTENTION:
Once the dash kit is
snapped in, it cannot be removed
without dash panel removal.
3
(Figure A)
(Figure B)
.
(Figure C)