Setup 3: Bundle The Cords And Cables; Setup 4: Turn On The Monitor And Computer - Sony SDM-S204 Manual De Instrucciones

Setup 3: Bundle the cords and
cables
1 Slide up the back cover.
2 Remove the stand cover.
3 Secure the video signal cables using the cable
holder on the cabinet.
4 Feed the power cord through the hole on the left of
the stand and secure the power cord and video
signal cables using the cable holder.
5 Replace the stand cover and then slide down the
back cover.
Please be sure that cords come out through the opening at the
bottom of the stand cover, for proper placement of the stand
cover.
1 5
back cover
3 4
cable holder
8
Setup 4: Turn on the monitor and
1 Press the MAIN POWER switch located on the right
Note
The monitor is factory shipped with the MAIN POWER switch set
to on ([).
2 Press the 1 (power) switch on the front right of the
2 5
stand
cover
3 Turn on the computer.
4 Press the INPUT button to select the desired input
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 11).
computer
side of the monitor in the direction of the [, if it is not
already pressed. Make sure the 1 (power) indicator
is lit in red.
MAIN POWER
monitor.
The 1 (power) indicator lights up in green.
signal.
The selected input's picture appears on the screen.
For more information, see "Selecting the input signal (INPUT
button)" on page 10.
INPUT
lights in red
lights in green