Power Supply Modules - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Chapter 1 Product Overview
Figure 1-8 Select and Standby/Active Buttons
S T D B Y
D C O U T
/
A C T IV E
1
2
T E M P 3
F A N
S E L E C T
1
Select button
1
Standby/Active button
2

Power Supply Modules

Note
78-17647-02
R e d u n d a
n t P o w e r
P U T
S y s te m 2
3 0 0
4
5
6
S T D B Y /
A C T IV E
2
The RPS 2300 is powered through the power supply modules. The modules slide
into the power supply slots in the front of the RPS 2300 and use their own AC
power cord. (See Figure 1-6 on page
a 15-A, 110-VAC power connector.
The RPS 2300 supports these power supply modules:
C3K-PWR-1150AC
•
C3K-PWR-750AC
•
The RPS 2300 does not support the C3K-PWR-265AC and C3K-PWR-265DC
power supply modules.
The RPS 2300 can be configured with one or two power supply modules. If you
install two power-supply modules they must be the same type. You cannot insert
a 750-W and a 1150-W power supply module in the RPS 2300 at the same time.
Cisco Redundant Power System 2300 Hardware Installation Guide
1-8.) Both modules use a 16-AWG cord and
Power Supply Modules
1-13