Statement 294-Class A Warning For Korea; Installation Guidelines - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Chapter 2 RPS 2300 Installation
Statement 294—Class A Warning for Korea
Warning

Installation Guidelines

78-17647-02
This is a Class A Device and is registered for EMC requirements for industrial
use. The seller or buyer should be aware of this. If this type was sold or
purchased by mistake, it should be replaced with a residential-use type.
Statement 294
When deciding where to place the RPS 2300, be sure to observe these guidelines:
Operating environment is within the ranges listed in
•
Specifications."
Airflow around the RPS 2300 and through the vents is unrestricted.
•
Clearance to the front and rear panel is such that:
•
Front-panel indicators can be easily read.
–
Access to ports is sufficient for unrestricted cabling.
–
AC power cord can reach from the AC power outlet to the power supply
–
modules on the RPS 2300 front panel.
Cabling is away from sources of electrical noise, such as radios, power lines,
•
and fluorescent lighting fixtures. Make sure the cabling is safely away from
other devices that might damage the cables.
To provide enough distance for cabling, place switches and routers using the
RPS 2300 close to the RPS. The maximum RPS cable length is 1.5 meters.
If only one power supply is installed in the RPS 2300, the spare power supply
•
insert that ships with RPS 2300 must be installed in the empty power supply
slot.
Cisco Redundant Power System 2300 Hardware Installation Guide
Preparing for Installation
Appendix A, "Technical
2-7