Installation Clearances - TECO UPH Manual De Instrucciones

INSTALLATION CLEARANCES

Bring the tyre changer to the required working position, meeting the minimum meas-
urements indicated in the tyre changer manual. Fig.1
Note:
Installation of the UPH on the tyre changer may be carried out by qualified and au-
thorised personnel only. Installation by NON-qualified personnel implies the loss of the
warranty on the performance of the device.
The UPH accessory may only be installed on our tyre changers of the type.
fig. 5 for
- Disconnect the electrical and pneumatic connections.
- Demount the side casing of the tyre changer.
- On a non TI tyre changer (i.e. a tyre changer without tubeless tyres inflating device),
it is necessary to demount the reducing valve. Make a new fixing hole in the position
shown in fig.3 and re-mount it.
- Check whether the machine has the holes needed to mount the UPH accessory.
- If the holes are lacking, apply them following the scheme supplied with the machine
or in fig. 50. If the scheme is missing, stop installing and call the supplier.
- Fix the UPH as shown in fig 6 (using the relevant screws) taking care to insert the
reinforcing plate (fig. 6) inside the body of the tyre changer.
- Demount the L connection (A fig.4) and mount in its place the double connection (B
fig. 4)
- Connect the UPH supply pipe to the double connection (B fig. 4)
- Mount the side casing.
CALIBRATION OF THE BEADPRESSING ARM
fig.7
- Secure one wheel to the turntable, bring the Beadpressing Arm to the working posi-
tion.
- If the centring cone of the arm is not in the centre of the wheel, act on the screws
securing the UPH.
22
INSTALLATION
VERSION OF THE UPH
UPH operator's manual