TECO UPH Manual De Instrucciones página 28

Note:
The rest is fully inserted when the small roller touches the upper edge of the rim.
WARNING
While inserting the rest, the upper bead must not enter the rim housing on which the
inflation pressure sensor is mounted; doing so might damage it.
(Common procedure for Pax System with full width and clipé rest)
- Remove the lower bead from the lower edge of the rim using a standard lever (better
if protected by a plastic sheath) fig. 40
- Place the selector (E) on position 3
- Move the cylindrical roller to the lower part of the tyre
- Press the roller onto the edge of the rim
- Couple the bead inserter (K in fig. 8) to the wheel support shaft and insert the mount
hook between the rim and the bead, at about 10 cm from the roller fig. 41
- Put the bead in its housing, rotate the wheel at minimum speed and while advancing
gradually, stop before the bead inserter interferes with the roller.
- At completion release the bead inserter from the wheel
(Common procedure for Pax System with full width and clipé rest)
- Replace the double roller tool with the cylindrical roller
- Move the cylindrical roller to the upper part of the tyre
- While acting on the pneumatic lever switch (G), press the roller onto the edge of the
rim fig. 42
- Couple the bead inserter (K in fig. 8) to the wheel support shaft, and insert the mount
hook between the rim and the bead, at about 10 cm from the roller fig. 42
- Put the bead in its housing, rotate the wheel at minimum speed and while advancing
gradually, stop before the bead inserter interferes with the roller.
- At completion release the bead inserter from the wheel
- Remove the roller by pushing it axially.
- Inflate the tyre fig. 43 using the special air gun connected to the tyre changer.
- Make sure the beads are properly inserted in their housing.
WARNING
The maximum inflation pressure recommended by the manufacturer must never be
exceeded for any reason whatsoever – DANGER OF DAMAGE TO THE TYRE.
28
Mounting the lower bead
Mounting the upper bead
UPH operator's manual