TECO UPH Manual De Instrucciones página 23

CALIBRATION OF THE PAX VERSION
fig.7
- Secure the wheel support (C in fig. 8) to the turntable, secure one PAX wheel to the
wheel support, approach the roller of the horizontal arm (B in fig.8) to the edge of the
rim.
- If the roller is not tangent to the edge of the rim and/or slight misalignments are
observed, act on the screws securing the UPH.
DESCRIPTION OF THE UPH
fig. 8 , 8-1
A1. Roller arm (fig 8-1)
B. Horizontal arm with cylindrical roller
B1. Bead presser roller (fig 8-1)
C. PAX wheel support
D. Anti-rotation plug
E. Selector
E1. Bead lifter disk (fig 8-1)
F. Horizontal arm clamping handle
F1. Jack (fig 8-1)
G. Pneumatic switch
G1. Extension for wheel centring cone (fig
8-1)
H. Locking ring-nut
I. Locking ring-nut wrench
J. Double roller and claw tool (for clipé
WARNING
Before starting demounting it is important to check the code on the wheel which indi-
cates the type of Pax tyre - standard or Clipé -.
WARNING
For any work on the valve or on the pressure transducer, consult and follow the op-
erator's manual supplied by the transducer manufacturer.
UPH operator's manual
OF THE UPH
wheels)
K. Bead inserter
L. Bead demounting lever
M. Rim guard (Réglette)
N. Small cone
O. Large cone
P. Tool securing pin
Q. Inclined disk (for clipé wheels)
R. PAX tyre fig. 30
S. Support fig. 30
T. Special Pax profile rim fig. 30
U. Cylindrical roller
V. Rim clamp arm (fig 8-1)
Z. Centring cone (fig 8-1)
GB
23