Ego Power+ SNT2400 Manual Del Operador página 16

TO INSTALL THE SNOW-
DISCHARGE CHUTE ASSEMBLY
WARNING:
snow blower without the complete
discharge chute in place.
1. Loosen the knob on the inner
support pole and remove the bolt
(Fig.5). Save the knob and bolt for
reassembly.
2. Lift the snow-discharge chute
assembly, align the outer support
pole with the inner support pole,
and then slide the outer support
pole into place (Fig. 5). Make sure
that the snow-discharge chute is
correctly seated on the base (Fig.6).
3. Secure the snow discharge chute assembly with the reserved knob and bolt.
WARNING:
properly and that the discharge opening never crosses the operator controls.
16
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC
Never operate the
Use the chute rotation handle to make sure that the chute rotates
5
Snow-discharge
Chute
Bolt
Base
6
Snow-discharge
Chute
Base
Outer Support Pole
Knob
Inner Support Pole