Maintenance And Storage - Ego Power+ SNT2400 Manual Del Operador

◾
Use only with the battery packs and chargers listed below:
BATTERY PACK
BA1120, BA1120-FC, BA1400, BA1400-FC,
BA2240, BA2240-FC, BA2800, BA2800-FC,
BA4200, BA4200-FC, BA1400T, BA1400T-FC,
BA2800T, BA2800T-FC, BA4200T, BA4200T-FC,
BA5600T, BA5600T-FC
NOTICE: For best performance, recommend for use with 2pcs 5.0Ah or higher Ah batteries.
CLEARING A CLOGGING CHUTE
Hand contact with the rotating auger assembly inside the discharge chute is the most
common cause of injury associated with snow blowers. Never use your hand to clean
out the discharge chute.
To clear the chute:
◾
SHUT THE MOTOR OFF!
◾
Remove the battery pack(s) from the snow blower.
◾
Wait 10 seconds to be sure the auger has stopping rotating.
◾
Always use the chute clean tool which is attached to the machine as an
accessory, do not use your hand

MAINTENANCE AND STORAGE

◾
Check all bolts or fasteners at frequent intervals for proper tightness to be sure
the equipment is in safe working condition.
◾
Always refer to operator's manual for important details if the snow blower is to be
stored for an extended period.
◾
Maintain or replace safety and instruction labels, as necessary.
◾
Run the machine a few minutes after blowing snow to prevent freeze-up of the
auger assembly.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others
who may use this tool. If you lend this tool to someone else, also lend these instructions
to them to prevent misuse of the product and possibly injury.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC
CHARGER
CH2100, CH2100-FC,
CH5500, CH5500-FC,
CH2800D, CH2800D-FC
9