Ego Power+ SNT2400 Manual Del Operador página 20

To Start the Snow Blower
1. Ensure that the handle assembly is securely adjusted to appropriate height, the
side-discharge chute assembly is mounted properly, and the chute and chute
deflector are adjusted to an appropriate position.
2. Attach the battery pack(s) to the snow blower and close the battery cover.
NOTICE:
Make sure that the latch on the snow blower snaps into place and that the
battery pack(s) are secured to the snow blower before operation.
3. Press the safety button and hold for
1 second, and the LED indicator will
blink green. Press the auger-switch
trigger to turn on the snow blower
while the LED indicator blinks
(Fig.13).
NOTICE:
The snow blower can be
turned on by the auger-switch-trigger only
when the LED indicator blinks.
NOTICE:
The snow blower may not properly start if its battery temperature is -4°F
(-20°C) or less. If the snow blower doesn't start, remove the battery from the snow
blower and allow it to warm indoors for 10 minutes or longer. Reinstall the battery and
try again.
To Stop the Snow Blower
1. Fully release the auger-switch trigger.
2. The electric brake in the Automatic Braking Mechanism will stop the auger
rotation within 3 seconds of the auger-switch release.
Variable-Auger-Speed System (Fig. 13)
The speed of the auger can be adjusted to control the throwing distance.
1. To increase the speed, push the auger-speed-control lever forwards.
2. To decrease the speed, pull the auger-speed-control lever backwards.
20
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC
13
Auger-Switch Trigger
Auger-Speed-Control Lever
Safety Button