Ego Power+ SNT2400 Manual Del Operador página 31

REPLACING THE AUGER
1. Remove the batteries.
2. Remove the two locking screws on
the top of the deck (Fig.27).
3. Remove the three flange screws
on both left and right of the deck
(Fig.28).
4. Remove the auger, together with
the gearbox as a whole set from
the deck. Then remove the flange,
bushing and gasket from the auger
shaft (Fig.29).
5. Remove the left and right shear pin
and separate the augers from the
auger shaft (Fig.30).
6. Replace the worn auger and
reassemble them in reverse order.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC
27
Locking Screw
28
29
Flange
Gasket
Bushing
Gear Box
30
Auger Shaft
Flange Screw
Auger Auger Shaft
Auger
Shear Pin
31