Maintenance; General Maintenance; Lubricating The Machine - Ego Power+ SNT2400 Manual Del Operador

MAINTENANCE

WARNING:
the snow blower before cleaning or performing any maintenance.
WARNING:
parts may create a hazard or cause product damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
NOTICE:
Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
penetrating oils, etc. come in contact with plastic parts. Chemicals can damage, weaken, or
destroy plastic which can result in serious personal injury.

LUBRICATING THE MACHINE

All of the bearings in this product are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
bearing lubrication is required.
MOUNTING AND DETACHING WHEEL
1. Remove the battery packs.
2. Lay the snow blower on its side, pull out the wheel-locking pin to remove the
outer gasket and the wheel. Save the inner gasket on the wheel shaft.
28
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC
To avoid serious personal injury, always remove the battery pack(s) from
When servicing, use only identical replacement parts. Use of any other
Do not at any time let brake fluids, gasoline, petroleum-based products,