Switch On; Foot Switch Settings; Handles With Buttons - HEBU medical HRF 100 x-touch Instrucciones Para El Uso

EN
Volume control
The volume of the activation and message signals can be adjusted using the controller on the rear of
the device. The speakers are also on the back. The sounds cannot be turned off.

7.3 Switch on

!
When using an electrosurgical unit which produces HF current, always
be aware of two fundamental principles:
Current flows through everything located between the active and
the neutral electrode (monopolar)
The system is switched on by actuating the main switch (ON/OFF). However, high-frequency current
only flows once a button is activated at the handle or foot switch.
Consequently, accessories can also be connected to the unit when it is switched on.
However, extreme care should always be taken when doing so!
!
Always ensure that the system is not inadvertently activated during
installation by pressing the foot switch or the button in the handle.

7.4 Foot switch settings

After connecting the foot switch at the back, the required mode must be set at the touchscreen. To set
the mode, touch the field indicating the foot switch symbol. This changes the text which appears
above the symbol.

7.5 Handles with buttons

Activating the handle with buttons takes place independently of the foot switch settings. These cannot
be activated using the foot switch.
!
46
Make the necessary connections with the device switched off!
HBS x-touch 200i