Commissioning The Unit; Before Starting Work; Installation Of The Device - HEBU medical HRF 100 x-touch Instrucciones Para El Uso

HBS x-touch 200i
7

Commissioning the unit

7.1 Before starting work

According to its specification, the device can only be installed and
!
supplier and who operate the device correctly in accordance with the
Make sure that the surface on which the device is placed is at least as large as the device and not
inclined by more than 10 ° to the horizon. HEBUmedical recommends putting the device on a trolley
provided by the company.
Check that the cooling openings on the lower side of the device are not blocked and that air can
circulate freely

7.2 Installation of the device

Mains connection
•
Connect the power cord
•
Only connect the device to the mains with the power cord supplied or with a cable of the
same quality that has the mark required by national legislation for a passed test.
•
Connect the device with the yellow - green earth cable to the earth socket (8), which is located
next to the mains supply socket.
•
Make sure that there are no other connections and switch on with the on / off switch in the
lower right corner of the front of the device to check whether it lights up. Then switch off the
device again
Autotest at switching on:
!
Turn on a device. You will hear an original message, the LCD panel will display the start page and an
autotest will be carried out.
Errors in the system
!
used in rooms for medical purposes.
Only people who have been trained by the manufacturer or the
instructions for use may work with the device.
Do not place any containers with liquids on or near the device.
Caution: Before switching on, make sure that all connections are
correctly connected and that the active electrodes are not in
contact with the patient, with a third person or with a conductive
Under no circumstances should you use the device if an error
message appears at any given time!
material.
EN
45