Intended Use; Staff Training; General Precautions - Ravaglioli RAV TD4400 Serie Instrucciones Para El Uso

RAVAGLIOLI S.p.A.

1 INTENDED USE

The RAV TD4400 systems are machines for determining all the angles relating to vehicle
wheel alignment.
These angles are measured by four sensors incorporating microprocessor technology and
infrared data reading and transmission system.
Data transmission from the lift platforms to the console is VIA RADIO by means of
modules
The machine must only be used in a field of temperature from 0° to 40°.

2 STAFF TRAINING

The machine must only be used by specially trained and authorised personnel. To
ensure best machine management and that measurements can be efficiently made,
operators must be properly trained in order to acquire the know-how needed to use the
machine according to the instructions provided by the manufacturer. In case of any
doubts relating to the use and maintenance of this machine, refer to the instruction
manual; if doubts still remain, contact authorised after-sales services or the RAVAGLIOLI
S.p.A. technical department.

2.1 General precautions

•
During machine operation and maintenance, always follow all applicable
safety and accident-prevention norms.
•
The machine must only be used by authorised and adequately trained
personnel.
•
This machine must only be used for the purpose for which it was specifically
made.
RAVAGLIOLI S.p.A. disclaims all liability for injuries to persons or anuimals
and damage caused to things by incorrect machine use.
•
Accessories and spare parts must only be fitted by authorised RAVAGLIOLI
S.p.A. personnel and original accessories and spare parts must always be
used.
•
The machine must only operate in places where there is no risk of explosion
or fire.
•
Removing or altering safety devices or the warning signals on the machine
can represent a cause of serious hazard and is an infringement of European
safety laws.
•
Before doing any maintenance jobs on the system, disconnect the power
supply.
In case of doubt, do not interpret but contact the RAVAGLIOLI S.p.A. after-
sales service to receive instructions on how to perform operations in
conditions of utmost safety.
•
Avoid unauthorised persons coming near the wheel aligner during operation.
RAVAGLIOLI S.p.A. – 40044 Pontecchio Marconi (BO) Via I Maggio, 3
.
Tel. (+39) 051/ 67.81.511 – Fax (+39) 051/ 84.64.67
e-mail: rav@ravaglioli.com
RAV TD4400
/http www.ravaglioli.com
OPERATOR'S MANUAL
Code M0150 - rev.1.0
(01/2008)
Page 3/ 15