Steren COM-817 Manual De Instrucciones página 71

- Wireless network status: You can choose "enable" or "disable" to enable
or disable the "Wireless Network Status". If you choose "Disable", the AP
function of wireless repeater will be turned off.
- SSID: The default is trst1.
- Radio band: You can select the wireless standards running on your
network, if you have Wireless-N and Wireless-B/G devices in your network,
keep the default setting, 802.11b+g+n
- Radio mode: You can select radio mode of wireless repeater, it contains
Access Point, Client, AP+WDS and WDS. The default setting is AP mode.
- MAC: Wireless repeater's physical address.
- SSID Broadcasting: You can select "enable" or "disable" to enable or
disable the broadcast SSID function, If the setting of this field is disable,
wireless client can't obtain this SSID to login in, then user have to input the
SSID value manually.
- Channel width: This switch allows you to set Repeater's wireless bandwidth.
20MHz: In this mode you can get low bandwidth, little interference and slow
rate. 40MHz: In this mode you can get high bandwidth, high interference
and rapid rate. Use only when you have a pure repeater, draft 802.11n
wireless network.
- Channel sideband: It controls your wireless repeater to use higher or
lower channel when working on 40MHz.
- Region: please select the region where you live in.
- Channel: In 20MHz, you can select one channel from 1 to 13 manually,
and in 40MHz, you can select one channel from 1 to 9 or 5 to 13, which
provides a choice of avoiding interference.
26 26