Steren COM-817 Manual De Instrucciones página 87

- If WAN LED is ON, open the System Overview page of the Web configuration
utility and check the status group to see if the repeater' s WAN port has suc-
cessfully obtained an IP address.
- Use th- Make sure you are using the correction method (Dynamic IP Address,
PPPoE, or Static IP) as required by the ISP. Also ensure you have entered the
correct settings provided by the ISP.
- For cable users, if your ISP requires a registered Ethernet card MAC address,
make sure you have cloned the network adapter' s MAC address to the WAN port
of the repeater. (See the MAC Address field in WAN Setup.)
5) My wireless client cannot communicate with another Ethernet computer.
- Ensure the wireless adapter functions properly. You may open the Device
Manager in Windows to see if the adapter is properly installed.
- Make sure the wireless client uses the same SSID and security settings (if
enabled) as the COM-817 Repeater.
- Ensure that the wireless adapter's TCP/IP settings are correct as required by
your network administrator.
- If you are using a 802.11b wireless adapter, and check that the 802.11G
Mode item in Wireless Basic Setting page, is not configured to use 802.11G
Performance.
- Use the ping command to verify that the wireless client is able to communicate
with the repeater's LAN port and with the remote computer. If the wireless client
can successfully ping the repeater' s LAN port but fails to ping the remote com-
puter, then verify the TCP/IP settings of the remote computer.
42 42