Surface Mounting - ETI Solid State Lighting 55301101 Guía De Uso Y Cuidado

surface Mounting

1
Preparing the sign for mounting
□ Press in the two tabs at the top and the two tabs at the bottom of the exit sign
housing (A) to release the front exit sign faceplate (B).
□ Remove the cardboard packing and the hardware packet containing the
mounting bracket (AA), mounting canopy (BB), wire connectors (CC), and
electrical box screws (DD).
□ Gently detach the red or green plastic overlay from the exit sign faceplate (B).
□ Pop out one of the directional arrows from the exit sign faceplate (B), based on
the mounting location.
□ Reattach the red or green plastic overlay to the exit sign faceplate (B).
□ Press in the two tabs at the top and the two tabs at the bottom of the exit sign
housing (A) to release the back cover.
□ Align the back cover mounting template with the electrical box to determine
which knockouts to remove for mounting.
□ Drill out the required knockouts with a power drill.
2
Mounting the exit sign housing to the electrical box
□ Attach the electrical box screws (DD) directly to the electrical box, but do not
tighten fully.
□ Feed the wires from the electrical box through the knock out in the back cover
of the exit sign housing (A), adding the jumper wires (EE) if needed for additional
length.
□ Align the open keyholes in the back cover of the exit sign housing (A) with the
electrical box screws (DD), allowing the heads of the screws to come through
the large ends of the keyholes.
□ Rotate the back cover of the exit sign housing (A) until the heads of the electrical
box screws (DD) slide into the narrow ends of the keyholes.
□ Tighten the electrical box screws (DD) to secure the back cover of the exit sign
housing (A) to the electrical box.
□ Reattach the exit sign housing (A) to the back cover.
Back Cover
B
A
A
Back
Cover
DD
A
6
surface Mounting (continued)
3
Making the electrical connections
If wiring to a 277v AC circuit:
□ Connect the red wire from the exit sign housing (A) to the hot wire from the
electrical box.
□ Connect the white wire from the exit sign housing (A) to the neutral wire from the
electrical box.
□ Cover the wire connections using the wire connectors (CC).
□ Wrap the wire connectors (CC) with electrical tape for a more secure connection.
□ Cap the unused black wire from the exit sign housing (A) with a wire
connector (CC) and electrical tape.
If wiring to a 120v AC circuit:
□ Connect the black wire from the exit sign housing (A) to the hot wire from the
electrical box.
□ Connect the white wire from the exit sign housing (A) to the neutral wire from the
electrical box.
□ Cover the wire connections using the wire connectors (CC).
□ Wrap the wire connectors (CC) with electrical tape for a more secure connection.
□ Cap the unused red wire from the exit sign housing (A) with a wire connector (CC)
and electrical tape.
To connect the battery back-up:
□ Plug the connector on the end of the red and black wires coming from blue battery
pack into the connector near the end of the PC board mounted in the bottom of the
exit sign housing (A).
4
Completing the installation
□ Snap the exit sign faceplate (B) back onto the exit sign housing (A).
□ Restore power at the electrical panel. The red AC Indicator on the
bottom of the exit sign housing (A) should illuminate red.
CC
Battery Pack
Connector
B
A
AC Indicator
7 WWW.ETiSSL.COM
Please contact 1-855-384-7754 for further assistance.