Movement R5i Manual Del Usuario página 58

Ocultar thumbs Ver también para R5i:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LUBRICATION
The belt is lubricated at the factory. However, it is recommended to check the belt lubrication
regularly to ensure its correct functioning. Generally, it is not necessary to lubricate the belt for
the first year or the first 500 hours of operation. Every 3 months of operation, lift the sides of the
belt and run your hand over the running belt surface as far as it will go. If signs of silicone are
found, there is no need to lubricate. If the surface is dry, follow the instructions below. Only use
oil-free silicone.
Lubricant application on running belt:
Lubricant application on running belt:
●Position the running belt so that the seam is located in the middle of the platform.
●Insert the valve into the spray tip of the lubricant bottle.
●Lift the tarpaulin on one side and hold the spray valve at a distance from the front of the
tarpaulin and the platform. Start at the front of the running belt. Move the spray valve towards the
from behind. Repeat the process on the other side of the running belt. Spray each side for about
4 seconds.
● Wait a minute to allow the silicone to spread before connecting the belt.
Fig 1
Fig 2
1 - Insert the extension (B) into
the vessel (A) and remove the
cover (C ).
2 - Consult the manual and
follow the steps for lubricating
the tarpaulin.
3 - Put on the protective cap (C)
and the cap (D) after use.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido