Tools Needed For Assembly; Unpacking Instructions - Fanimation SLINGER v2 Manual De Instrucciones

This manual is designed to make it as easy as possible for you to assemble,
install, operate and maintain your ceiling fan

Tools Needed for Assembly

ne hillips head screwdriver
One stepladder
Foue wire connectors
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 10). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Downrod/
Hanger Ball Assembly
Canopy Screw
Cover Assembly
Motor Coupling
Cover Assembly
One wire stripper
One lade
screwdriver
WARNING

Unpacking Instructions

Ceiling Canopy
Motor Assembly
Light Plate Assembly
Materials
iring outlet o and o connectors
re uired y the local code
conductor wire with ground of the following si e:
nstalled ire ength
p to ft
ft
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
otor sse ly
anger racket sse
ownrod anger all sse
Ceiling Canopy
Canopy crew Cover sse
otor Coupling Cover sse
lade Cover et
lade older et
lade et
ight late sse ly
Light Kit Assembly
LED Assembly
teel Cap
Hand-Held Remote
Light Kit Assembly
LED Assembly
Steel Cap
4
ust e of type
he ini u wire would e a
ire i e
ardware ags:
ly
– an ead
errated crew
ly
lade to lade holder
– an ead crew
ly
lade holder to
ly
– our ire Connectors
– alance it
Blade Cover Set
Blade Holder Set
Hand-Held
Remote
Hardware Bags
Blade Set
otor