Publicidad
Assembly Instructions
Fig. 40
2 FOR FUN SWING.
1. Thread chains through 2 for Fun handles as shown in (Fig. 40).
2. Attach handle assembly to seat using (1) 6 1/4" hex head bolts, (1) 5/16" loc washer, (2) 5/16" washers,
and (1) 5/16" loc nut as shown in (Fig. 40). Repeat this for the other side.
NOTE: Do not overtighten bolts. The bolt threads should not extend beyond the end of loc nut.
Overtightening can damage the 2 For Fun Glider assembly and cause injury. Check this connection
frequently to see if the loc nut stays in position. If there is any problem keeping the loc nut in position,
replace it immediately.
3. Attach 2 for Fun Glider to set. Crimp all swing hangers and clamps tightly as shown in (Fig. 40a).
50
Fig. 40a
Publicidad
