Gude GME 6.5 V Traducción Del Manual De Instrucciones Original página 51

Failure removal
Failures
Engine not starting
low power
No drive or drive slipping
Drehzahl passt nicht mir der
Einstellung überein
Unsteady running, strong
vibrations
Transitions can not be inserted
Basic clutch adjusting, Drive adjusting and the Output shaft adjusting is provided in the factory. However, the
tow pull may get slightly loosened due to a frequent control. When the tow cable is too loose, it can cause pro-
blems as the equipment clutch cannot be inserted properly. If this is the case, the tow cable must be tightened.
On our website (search No. 95187) you can download a setting information.
causes
Fuel tap closed
contaminated fuel
Petrol tank empty
Spark plug dirty from oil or
defective
Wrong gas lever position
Dirty air filter
Clutch slipping
cable adjusted
Components and screwed connec-
tion loosened
Only at standstill
removal
Open the fuel tap
fuel tank change
Add petrol
Clean or replace the spark plug
21
Correct the settings
Clean or replace the air filter
22-23
Adjust the cable
18
Consult with the customer service
centre
Adjust the cable
18
Consult with the customer service
centre
Stop the engine and retighten
screw check /; damaged parts
replaced
Consult with the customer service
centre
Stop before shifting
ENGLISH
47