Installation Instructions - Acuity Brands AEDAN Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

STEP-BY-STEP GUIDE
DO NOT EXERT PRESSURE IN THE MIDDLE OF OLED PANELS. WEAR GLOVES DURING INSTALLATION. NOTE: TURN OFF
POWER ON CIRCUIT BREAKER BOX!
1
1.
2.
2
2a.
2b.
6
Remove fixture components and parts pack(s). Check that all parts are included. Assistance may
be required to support fixture during installation.
INSTALL JUNCTION BOX AND PULL WIRES THROUGH: Prior to wiring the fixture, disconnect
ALL power supplies to the unit. Make all wiring connections inside the junction box. The fixtures
should be wired in accordance with NEC and applicable local codes and ordinances.
Select desired location on wall and install a recessed junction box (4" octagonal or full-size round
or square j-box, or dual-gang switchbox, supplied by others).
Connect 120V AC power to the junction box and pull wires through (AC power hot BLACK, neutral
WHITE, ground GREEN, and optional dimmer leads PURPLE and GREY).
(Figure 2b)