Assembly And Operation - KRESS KUH10 Manual De Instrucciones

over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING
INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When replacing
the battery pack, do not
insert the battery until the
Grinding/Cutting Disc comes to
a complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Adjusting Wheel Guard
Note: Before any work on the
machine itself, remove the
battery pack. For work with
grinding or cutting discs, the
protection guard must be
mounted. Use the correct type
of disc for your application. If
the power tool is intended to
perform cutting off operations, a
guard specific for this operation
must be fitted.
The coded projection on the wheel
guard ensures that only a guard
that fits the machine type can be
mounted.
Open the clamping lever. Place the
wheel guard with coded projection
into the coded groove on the spindle
of the machine head and rotate
to the required position (working
position).
To fasten the wheel guard, close the
clamping lever.
The closed side of the wheel
guard must always point to the
operator.
OPERATION
FIGURE
Using On/Off Switch
See Fig. A1
Variable Speed Control
See Fig. A2
Hand Grip Areas
Rough Grinding
Warning! Never use a
cutting disc for roughing.
See Fig. A3
Cutting
See Fig. B
See Fig. C1,
C2, C3
See Fig. D
See Fig. E
11
See Fig. F
EN
See Fig. G
See Fig. H