WORKING HINTS FOR
YOUR ANGLE GRINDER
1.
Always start at no load to achieve maximum speed
then start working.
2.
Do not force the disc to work faster, reducing the
Disc's moving speed means longer working time.
3.
Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4.
When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only
cut in the opposite direction to the disc rotation. If
you cut in the same direction as the disc rotation
the disc may push itself out of the cut slot.
5.
When cutting very hard material best results can be
achieved with a diamond disc.
6.
When using a diamond disc it will become very
hot. If this happens you will see a full ring of sparks
around the rotating disc. Stop cutting and allow to
cool at no load speed for 2-3 minutes.
7.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
MAINTENANCE
Remove the battery before carrying out any
12
adjustment, servicing or maintenance.
There are no user serviceable parts in your power
EN
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your
power tool.
TROUBLESHOOTING
Although your new angle grinder is really very simple to
operate, if you do experience problems, please check
the following:
1.
If your grinder wheel wobbles or vibrates, check
that outer flange is tight; check that the wheel is
correctly located on the flange plate.
2.
If there is any evidence that the wheel is damaged
do not use as the damaged wheel may disintegrate,
remove it and replace with a new wheel. Dispose of
old wheels sensibly.
3.
If working on aluminum or a similar soft alloy, the
wheel will soon become clogged and will not grind
effectively.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice.
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Angle grinder
Type KUH10 KUH10.91 (H10 - designation of
machinery, representative of angle grinder)
Function peripheral and lateral grinding
Complies with the following Directives:
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN 55014-1
EN 55014-2
EN 60745-1
EN 60745-2-3
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne,Germany
2021/02/05
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China