installation
1
Positioning the LED fixture
□ Identify the desired location for the LED fixture.
□ Place the U clips (AA) in the desired location and mark their
intended position through the holes with a pencil.
□ For drywall application, drill and tap in drywall
anchors (BB).
AA
3
Connecting the power cord
□ Connect the power cord (B) to the installed light fixture (A).
WarninG: Do not plug the power cord (B) into the
wall until after connecting the power cord (B) to the
light fixture (A).
□ Affix the power cord (B) to the underside of the cabinet with
wire clips (not included), if desired.
2
Installing the light fixture
□ Secure each U clip (AA) in place with the mounting
screws (BB).
□ To secure the fixture (A) in place, press it evenly into the
U clips (AA).
nOTe: Screws must be installed flush with surface.
AA
BB
A
B
A
4
installation (continued)
4
Adjusting the light level
□ Use the 3-position switch on the fixture (A) to control the light.
□ Press down on the left side of the switch for 50% brightness.
□ Position the switch in the middle to turn off the fixture.
□ Press down on the right side of the switch for 100% brightness.
Linking Feature
WarninG: risK OF eLeCTriC sHOCK. Disconnect power to the under cabinet light before linking additional light fixtures.
Provide power to the fixtures only after all linking connections have been made.
Multiple light fixtures can be connected, up to a maximum of 300 total
watts. Only the first light fixture needs to be plugged into an electrical
outlet.
□ Connect each additional under cabinet light fixture (A) using either
the linking cable (C) or end-to-end connector (D).
□ Remove the end cover and insert either the end-to-end connector
(D) or linking cable (C) into the receptacle in the end of each light
fixture (A).
Model No .
Part No .
Maximum Connected Units
54194112
UC-24-11-830-SV
20
54195112
UC-18-8-830-SV
25
54196112
UC-12-6-830-SV
30
54197112
UC-9-4-830-SV
40
A
3-Position Switch
A
5
www.ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
End Cap