nVent RAYCHEM JBS-100-A Instrucciones De Instalación página 4

5A
BTV and QTVR
• Push braid back to
create a pucker.
• At pucker use a screwdriver
to open braid.
• Bend heating cable and work
it through opening in braid.
• Lightly score inner
jacket around and
down as shown.
• Peel off inner jacket.
• Notch core.
• Peel bus wire
from core.
• Score core between
buswires at inner
jacket.
• Bend and snap core.
• Peel core from bus wire.
• Remove any remaining core
material from bus wires.
• Pull braid tight to make
pigtail.
4 | nVent.com/RAYCHEM
6 1/2 in
(165 mm)
1/4 in
(5 mm)
Go to Step 6
5B
XTV and KTV
• Push braid back to create
a pucker.
• At pucker use a screwdriver
to open braid.
• Bend heating cable and work
it through opening in braid.
• Lightly score inner
jacket around and
down as shown.
• Peel off inner jacket.
• Cut and remove
all fiber strands.
• Score and remove
center spacer.
• Remove any remaining
fiber material from
bus wires.
• Pull braid tight to
make pigtail.
6 1/2 in
(165 mm)
Go to Step 6