Publicidad
Idiomas disponibles
Idiomas disponibles
16
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide improved
vibration resistance, reduced maintenance and faster installation.
To connect wires, firmly insert a slotted screwdriver into the square hole
(
) to open the spring. When fully inserted, the screwdriver will lock
1
2
into place, allowing you to remove your hand and insert the wire into the
round hole (
). Remove the screwdriver to clamp the wire. The wire is
1
2
held securely against the bus bar for low contact resistance over time
without the need to periodically retighten screws.
• Push screwdriver FIRMLY into
square hole.
8 | nVent.com/RAYCHEM
• Insert wire into round hole.
• Use green terminal for braid and
ground wire.
1
2
Wire
Screwdriver slot
Wire hole
• Remove screwdriver.
• Repeat for all connections.
Publicidad
