Antenna Connections - Yamaha RX-V692 Manual De Instrucciones

ANTENNA CONNECTIONS

Each antenna should be connected to the designated terminals correctly, referring to the following diagram.
Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal
strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience
poor reception quality, an outdoor antenna may result in improvement.
Outdoor FM antenna
75-ohm coaxial cable
Connecting the AM loop antenna
1
* The AM loop antenna should be placed apart from the main unit. The antenna may be hung on a wall.
* The AM loop antenna should be kept connected, even if an outdoor AM antenna is connected to this unit.
GND terminal
For maximum safety and minimum interference, connect the
GND terminal to a good earth ground. A good earth ground is
a metal stake driven into moist earth.
75-ohm/300-ohm
antenna adapter
75-ohm/300-ohm
antenna adapter
300-ohm feeder
2
Indoor FM
antenna
(included)
GND
75Ω UNBAL.
FM
ANT
GND
AM
ANT
PHONO
Ground
3
Notes
When connecting the indoor
FM antenna, insert its
connector into the FM ANT
terminal firmly.
If you need an outdoor
FM antenna to improve
FM reception quality, either
300-ohm feeder or coaxial cable may be used. In locations
troubled by electrical interference, coaxial cable is
preferable.
Outdoor AM antenna
AM loop
antenna
(included)
Orient so that the best
reception is obtained.
15