ResMed VPAP Auto Guia Del Usuario página 23

4
After three minutes, the pressure reverts to the set pressure and treatment will
begin.
If you do not wish to wait three minutes, hold down the Start/Stop key
•
for at least three seconds to start treatment immediately.
If you press the Start/Stop key for less than three seconds, the device
•
will return to standby mode (the RAMP or SETTLING screen is displayed).
CPAP mode
(First screens only display if Ramp or Settling are selected)
Mode/Ramping Indicator
CPAP pressure
C:RAMP 8.0
A> exit
CPAP 15.0
A>> exit
Pressure Graph
Apnea Indicator
Minute ventilation (L/min)
Breath/phase/expiration
Average inspiration time
(last 5 breaths)
Note: (Set) values are those selected by the clinician.
Figure 5: Treatment screens (all modes)
The treatment screens contain the following information:
Treatment mode: Mode of treatment set by your clinician. Options are: CPAP,
S and VAuto.
Ramping indicator: (CPAP mode, S mode) Appears if the VPAP Auto is in ramp
mode. This disappears once the ramp time has elapsed.
Settling indicator: (VAuto mode) Appears if the VPAP Auto is in settling mode.
This disappears once the settling time has elapsed.
Set pressure(s): In CPAP mode, this displays the set treatment pressure
(centimeters of water). In S mode, it displays exhalation and inhalation pressures
(centimeters of water). In VAuto mode, it displays the EPAP and IPAP pressures
(centimeters of water).
Apnea indicator: (CPAP mode, VAuto mode) Visual indicator that displays an "A"
to indicate an apnea is occurring.
S mode
Mode/Ramping Indicator
(Set) EPAP pressure
S:RAMP 8.0-11.0
>>>> PS 3.0
Pressure Support
Mode
SPONT: 8.0-11.0
>>>> PS 3.0
Leak
LK: 24L/min RR: 12
MV: 12.0 VT:1000
S**TiMn TiMx 4.0
Ti 2.1s 1: 1.6
VAuto mode
Mode/Settling Indicator
(Set) IPAP pressure
VA:SETL
A>>>>
VAUTO
A>>>>
Respiratory rate (bpm)
Tidal volume (mL)
(Top row: VAuto and S mode only)
Ti Max setting (sec)
Average I:E ratio (last 5 breaths)
Operating Instructions
EPAP
IPAP
8.0-11.0
PS 3.0
(Set) PS
8.0-11.0
PS 3.0
15