Horizon Global 76364 Instrucciones De Instalación página 4

Trim bumper fascia – Measure to find the center of the fascia, mark a centerline on the
bottom of the fascia and trim as shown in Figure 2. Mark a centerline on the vertical
portion of fascia and trim as shown in Figure 3 * Do not trim away the bottom edge. *The
7.25" dimension is to make room for a trailer wiring connector, if not using trailer wiring
trim area can be 3.25" each side of the centerline of the fascia. Dimensions are
approximate and may be adjusted for fit and aesthetics*
Figure 2 Bottom View
Figure 3 Rear View
Leave the bottom edge!
7.25"
Lower exhaust - Lower the exhaust by removing (2) bolts from each
rear exhaust hanger bracket (1 per side) with a 13mm socket. Be sure
exhaust is supported to avoid damage.
©2020, 2021Horizon Global™ Corp - Printed in Mexico
3.25" TOTAL
3.25"
10.5"
Remove Excess Caulk- Remove excess caulk from the frame rails in the
hitch installation area and attachment holes.
Install hardware - Using the fish wire install items 1 and 2 as shown in
figure 1 through the access hole in the vehicle frame. Repeat for both
sides. Note: Keep the hardware inside the frame until hitch is in position,
keep fish wire attached to the hardware. See fig. 4 for example.
Sheet 4 of 15 76364NP 4-20-21 Rev. B