Waste Management; General Description; Charge Modes - GYS GYSFLASH 6.12 LITHIUM Manual Del Usuario

Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).

Waste management:

• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.

GENERAL DESCRIPTION

The GYSFLASH Lithium 6.12 is designed to charge the Lithium batteries of type Lithium Fer Phosphate (LFP / LiFePO4).
This charger has been designed to charge 12V batteries (4 elements in series) from 1.2 Ah to 125 Ah, or for floating charge up to
170 Ah.
START UP
1. Connect the charger to the battery using the proper accessory (clamps, lugs, etc...).
2. Plug the charger to the mains (single phase 220-240Vac 50-60Hz).
3. Select the mode by pressing the
4. During the charge, the device indicates the charge progress. When indicator
Once indicator stays on, the battery is fully charged.
5. The charge can be interrupted at any time by unplugging the mains plug or pressing the
6. After the charge, disconnect the charger from the mains, then disconnect the charger's connections from the battery.

CHARGE MODES

• Modes and Options description :
CHARGE mode
Mode designed for 12V lithium batteries, from 1.2Ah to 15Ah. 8 step automatic maintenance charge cycle.
CHARGE Mode
Mode designed for 12V lithium batteries, from 15 Ah to 125Ah and up to 170Ah for maintenance charge. 8 step
automatic maintenance charge cycle.
If the motorbike is fitted with a 12V plug, the GYSFLASH 6.12 can charge the battery via this plug with the CAN-BUS
system, without switching the dashboard on. In this setup, connect the cigratte lighter adapter (ref. 029439) on the
motorbike's 12V charger then follow the «start up » procedure on the previous page. In certain cases, it is possible
that the charge will only start 2 minutes after performing the connections.
Some Lithium batteries incorporate a UVP protection (Under Voltage Protection) which disconnect the battery in case
of deep discharge. This protection prevents the charger from detecting the battery. In order for the Gysflash Lithium
6.12 to charge the battery, it is necessary to deactivate the UVP protection. To do this, select the charging mode
(Moto or Auto), then press the button
automatically start charging.
GYSFLASH 6.12 LITHIUM
button. After roughly 5 seconds, the charge starts automatically.
(14.4V/4A) :
(14.4V/6A) :
for 10 seconds. The charger will then deactivate the UVP protection and
blinks, the battery is ready to start the vehicle.
button.
EN
7