INSTRUCTIONS FOR DISCHARGING GAS EMISSIONS
Type "A" appliances must discharge the products of combustion through extractor hoods or similar devices connected
to an efficient chimney, or directly outside. (Natural Discharge) Fig.1.
If there is no hood, as an alternative, an air extractor connected directly to the outside is acceptable, (Forced
Discharge) Fig.2, but its capacity must not be inferior to what is established in item 4.3 of the UNI-CIG norm 8723.
The gas supply to the appliance, must be directly interlocked to the system and must cut off automatically if its capacity
drops below the values prescribed by item 4.3 of the UNI-CIG norm 8723.
Supplying the appliance with gas again must only be possible manually.
NATURAL DISCHARGE Fig. 1
1) Extractor hood
Always keep the water level checked.
Attention! Do not start up the appliance without water.
Use the appliance only under surveillance.
Daily cleaning after switching off the appliance ensures the perfect functioning and long life of the appliance.
The parts in steel must be cleaned with a detergent-soaked cloth without rubbing; after that, rinse with clean water and
dry with a dry cloth.
WHAT TO DO IN THE EVENT OF A BREAKDOWN
Turn off the gas tap and notify the after sales service.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
Turn off the gas tap and clean the appliance as specified above.
GB
IT
Type "A" Appliances (See data plate)
In the event of forced discharge
FORCED DISCHARGE Fig. 2
OBSERVATIONS AND ADVICE
CLEANING AND MAINTENANCE
SOME TIME
32
IE
CH
1) Extractor hood
2) Interlocking