SATA AE5001H Manual Del Uso página 38

4.11 Adjustment for no-load test
- Clean the site and check that there is no oil stain on the ground and the lift is unloaded.
- Power on the lift, press UP button to lift the sliding table and then stop at any position. Then, press the oil return handle to lower the left
and right sliding tables to the same safety position.
- Tighten the balance wire rope nut to keep the tension of the two balance wire ropes basically the same.
- Press the UP button to lift the sliding table until it is out of the safety position, and then pull the left and right sliding table safety ropes
respectively and meanwhile press the oil return handle to lower the sliding table to the lowest position.
- Press the UP button to lift the sliding table continuously (if the limit switch is triggered when the sliding table is at any position, the motor
will stop). After the limit position is reached, the sliding table will trigger the limit switch and thus stop rising. Observe the synchronization
of the left and right sliding table bracket arms during this process, and continue to adjust the tightness of the balance wire rope nut if
significant difference exists.
- Install the door collision-prevention rubber pad.
4.12 Adjustment for load test
- Fully put the four bracket arms aside to ensure that the track is barrier-free.
- Drive to the middle position of the lift, and keep the length ratio of the front part to the rear part of the vehicle (for those equipped with
front engine) around 2:3 when the connecting line of the posts is taken as a reference. When the tonnage of the vehicle exceeds 3.5T, the
vehicle shall be moved backward appropriately.
- Rotate the bracket arm tray to the support point of the chassis.
- Press the UP button to lift the bracket arms and ensure the 4 bracket arm locks are completely engaged.
- Continue to inch it up until a rubber tray has contact with the support point of the chassis, and then rotate other rubber trays
counterclockwise to bring them into contact with the support point.
- Press the UP button to lift the vehicle slowly until all tires are off the ground. Gently push the rear of the vehicle to check that the vehicle
is fixed firmly and the bracket arm locks are completely engaged.
- Press the UP button to continue lifting the vehicle and observe if the vehicle is stable during this process. Stop lifting the vehicle when
the sliding table rises to the third or fourth safety position, and press the oil return handle, after which the oil will return to the hydraulic
station and the sliding table will be locked. Observe if the vehicle is stable (adjust the balance wire rope nut if there is an obvious height
difference between the left side and right side of the vehicle).
- Continue to lift the vehicle until it rises to the highest safety position, and then press the oil return handle, after which the oil will return
to the hydraulic station and the sliding table will be locked. Observe if the lift is stable without vibration.
- Inch the sliding table up until it is out of the safety position, and then pull the left and right sliding table safety ropes respectively and
meanwhile press the oil return handle, after which the vehicle will descend.
- While lifting the vehicle, check for abnormal sound and friction or interference between the wire rope and other components.
38
AE5001/AE5001-3
中文
EN DE RU KO PT JA ES